Seal along the edges of the interior and exterior trim with caulk. It should be equal at the top, middle and bottom. Watch our DIY Basics video, How Do I Use Spray Foam? Also shim behind the strike plate. Not ready to replace your front door, but looking for a refresh? Using another entrance, go inside and insert them into the gaps behind the hinges and between the jamb and framing to stabilize the jamb. wikiHow is where trusted research and expert knowledge come together.

Cut along the outline down to the sheathing. Place a solid shim behind the site of the lock strike. All Rights Reserved. Apply the first pieces of tape to the bottom sill.

For tips on applying caulk, take a look at our DIY Basics video: How Do I Use Caulk? If it's not, adjust the latch side of the door - in or out - and drill pilot holes in the frame at the top and bottom on the latch side. After covering the bottom of the frame opening, install a few pieces about six inches up the sides of the opening.

Close the door and shim above the middle screw. To test this out, place a piece of paper over the sill and close the door. To avoid damage to the wall, use door stoppers. Apply caulk to the corners along the edges of the cap, then install the self-stick corner pads that were included with the door. Stand outside and with the door closed, check where the weatherstripping on the frame contacts the door. From the inside, check that the frame is centered in the rough opening and still plumb. Measure both the door and rough opening to make sure the door is the right size. Check the directions. {"smallUrl":"https:\/\/www.wikihow.com\/images\/thumb\/4\/4f\/1368895-1.jpg\/v4-460px-1368895-1.jpg","bigUrl":"\/images\/thumb\/4\/4f\/1368895-1.jpg\/aid1368895-v4-728px-1368895-1.jpg","smallWidth":460,"smallHeight":345,"bigWidth":"728","bigHeight":"546","licensing":"